Operating procedures of the shearing machine series products
Release time: 2022-06-30 sentiment:527 time
1. The equipment should be operated by human beings, and others are not allowed to use it arbitrarily without training.
2. Before driving, check whether all parts are normal and whether the fasteners are firm.
3. It is prohibited to cut unannealed steel parts, cast iron parts, soft metal parts, over-thin parts, parts less than 100 mm in length, and parts that exceed the length of the scissors.
4. During operation, the human body is forbidden to be close to the transmission part and the knife edge of the equipment, and the safety of the surrounding personnel should be paid attention to to prevent the material from lifting up and hurting people. When cutting, the material should be cut as close as possible to the inside of the knife. When cutting shorter materials, do not use hand-held workpieces to feed materials, and use clamps to feed materials.
5. When the equipment is running, the operator is not allowed to leave the post privately, and the power supply should be blocked when the operation is over or temporarily leaving the post.
The various models of Nick mechanical shears have reliable performance, convenient operation and simple maintenance. There is no need to install foot screws, and where there is no power supply, diesel engines can be used as power. Contact consultation telephone 86-29-86031588