Daily maintenance of Monaco gantry shearing machine

No matter what machine must be checked for safety before starting operation, how to check the gantry shearing machine?
First of all, before starting the operation, check whether the screws on the machine are falling off. If there is no falling off, shake the screws of the gantry shearing machine by hand to see if it shakes. Make sure before opening the operation. The machine can be turned on without any shaking. Secondly, check the bearings to see if they need to be refueled. Ensure that the bearings are lubricated so that the machine can run smoothly.
After the preliminary inspection work is over, start to turn on the start switch button, and then go around the gantry shearing machine for a week to check whether the gantry shearing machine is operating normally and whether the steering is normal. During the operation, carefully listen to whether there is noise in the gantry shearing machine. If there is a noise, you need to find the source and check whether it is caused by damaged parts or lack of butter on the shaft. Do not start the gantry shearing machine after ensuring that there is no noise to prevent the operating life of the gantry shearing machine from being reduced due to small faults.
In the process of operation, if the efficiency of the gantry shearing machine is found to be much worse than before, the power supply must be cut off to check whether the cutter head of a gantry shearing machine is worn out too seriously. If the single disc wears too much, you need to change the blade. If the cutter head is not too badly worn, you can check whether the distance between the blades has become larger. If it becomes larger, adjust it normally.
If there are any problems with the equipment, whether it is inspection or maintenance, do not cut off the power supply for maintenance to avoid accidental injury to personnel.

In the process of using the gantry shearing machine, you should continue to accumulate experience and master the relevant skills and knowledge, so that the gantry shearing machine can better complete the task. www.nickbaler.com