Problems that are prone to occur in metal balers

Release time: 2022-09-07   sentiment:472 time

The baler is a common method in modern packaging. The baler is simple and lightweight, and will not bring extra burden to handling and storage. Therefore, the baler is indispensable for the packaging of food, electronics, beverages, cleaning, cosmetics and other industries. device of. In the process of daily use of the baler, the following problems are prone to occur. Let's take a look at it together.
1. The baler cannot detect the product: the consequence of not detecting the product is that the product is damaged, and the packaging work cannot be carried out normally. This happens mainly because the gap between the combined packaged products affects the detection of the electric eye, so it is only necessary to adjust the detection angle of the electric eye to an oblique angle.
2. The film material of the baler is easy to shift and cannot be fed normally: the above situation can be solved by adjusting the position of the film roll and the tension balance bar, and the adjustment is invalid, and then adjust the angle of the upper triangle plate.
3. What is the reason for the poor packing effect of the baler? In fact, there are many reasons, and there will be many manifestations
A. Improper adjustment of the tightening force
There are actually two reasons for this situation of the baler. One is that the tightening force of the baler is adjusted too much, which is mainly manifested in that the packing belt of the baler is deeply trapped in the carton, and the packaged items are damaged; If the tightening force is too small, its manifestation is that the packing belt is loosely tightened and cannot function as a binding.
2, the bonding effect is not good
The poor bonding effect does not completely mean that the baler is faulty, and it may also be that the quality of the strap itself is not good, which will also cause this result.
3. The cutting effect is not good
A perfect baling process should be good cutting tape and good bonding, but if the baler is used for a long time or is severely worn, there will be poor cutting of the packing tape, which will seriously affect the packing effect.


The above is the little knowledge about metal balers shared by NICKBALER. If you encounter other problems in use, you can feel free to contact our after-sales staff at 86-29-86031588.